Serving the New Orleans area  ·  (504) 636-6074  ·  Open Mon-Sun 7am-7pm
📞 (504) 636-6074 Free Quote

Metal Roofing in Chalmette, LA (70043) · Local Professionals

New Orleans Metal Roofing · Fast response in Chalmette and the New Orleans area · Free estimate 24h

✅ Licensed Contractor 🛡️ Licensed & Insured 💸 Free Quote 24h 🕐 Mon-Sun 7am-7pm
+273Verified Reviews
10Years in Business
4.9 ★Google Rating
24/7Available
✅ No hidden fees💳 Cards accepted🛡️ Licensed & Insured

Chalmette is a town of brick ranches and raised rebuilds, where the lots are tight and the storms are serious. If you live off Judge Perez Drive or near the Chalmette Battlefield, you know that a roof here has to handle wind-driven rain, summer sun, and the occasional falling oak limb.

Homeowners in Chalmette (70043) call New Orleans Metal Roofing because we understand St. Bernard Parish roofing. We have replaced storm-damaged panels near the Chalmette High School and installed standing seam on raised homes in the neighborhoods off Paris Road. When you need a roof that holds up, we are the local crew to call.

Metal Roofing in Chalmette (70043)

Chalmette sits on the east bank of the Mississippi, just downriver from New Orleans, and the ground here is low and flat. Many homes are raised, and the soil can shift, so proper fastening and flashing details matter more than ever. The housing stock is a mix of post-war brick ranches with low-pitch roofs and newer elevated homes built after the storms. Lots are typically narrow, and access can be tight, especially in the older neighborhoods near the levee. We know how to work in these conditions without damaging your landscaping or your neighbor's fence.

Our team has been serving Chalmette and the greater New Orleans area for years. We have seen how wind-driven rain can push water under improperly installed panels and how humidity can cause mildew on roofs that are not properly ventilated. That is why we pay close attention to every detail, from the underlayment to the ridge caps.

Our services in Chalmette

How a Job Works in Chalmette

Step 1: You call us at (504) 636-6074 or fill out our contact form. We schedule a free on-site assessment at your Chalmette property. We will inspect your current roof, take measurements, and discuss your options. You will get a written estimate before any work begins.

Step 2: Once you approve the estimate, we pull the necessary permits from St. Bernard Parish (or the appropriate authority) and schedule your installation. Our crews are experienced with the tight lot access common in Chalmette, and we take care to protect your siding, windows, and landscaping. We also coordinate with your HOA if you have one, to ensure the panel profile and color meet their guidelines.

Step 3: After the work is done, we do a thorough cleanup, including magnet sweeping for nails. We walk the job with you to make sure you are satisfied. We do not consider a job complete until you are happy with the result.

Metal roofing in Chalmette is priced per square foot, and the final cost depends on the size and complexity of your roof, the material you choose, and the condition of the existing structure. For a typical ranch home, metal roof installation starts at $8 per square foot, while standing seam runs from $10 per square foot. If you are replacing an old roof, metal roof replacement starts at $9 per square foot. For a tighter budget, metal roof over shingles (a retrofit) starts at $7 per square foot. Repairs, such as fixing a leak or replacing screws, start at $450. We also offer free estimates, so you can get a clear picture of what your project will cost. Call us at (504) 636-6074 to schedule yours.

My house is raised and near the Chalmette Battlefield. Does that affect how you install a metal roof?
Yes, raised homes often have different ventilation and access considerations. We account for the height and the slope of your roof, and we make sure the installation is secure against wind uplift. Being near the battlefield means you might be in a historic district, so we can help you choose a panel profile that meets any design guidelines.
A storm just blew through Chalmette and lifted some panels on my roof. Can you help quickly?
We offer storm and wind damage repair with free inspections. Call us at (504) 636-6074, and we will get out to your property as soon as possible to assess the damage and make temporary or permanent repairs. We work with your insurance company to document the damage.
What is the typical cost for a metal roof repair in Chalmette?
Most repairs start at $450, but the exact price depends on the extent of the damage and the type of metal roof you have. For example, a simple leak repair might be on the lower end, while replacing damaged panels or flashing could cost more. We provide a free estimate so you know the cost before we start.
Do I need a permit to replace my roof in Chalmette?
Yes, St. Bernard Parish requires permits for roof replacements and some repairs. We handle the permitting process for you, ensuring that the work meets local building codes and that inspections are scheduled. Permit fees vary based on the scope of work.
My neighbor and I share a property line, and I want to make sure my new metal roof does not cause drainage issues on their side. What should I do?
We can design your roof and gutter system to direct water away from the property line. If you have an HOA, we can also help you get approval for the roof design. It is always a good idea to discuss your plans with your neighbor before the work begins.
Are you insured for work on my Chalmette home?
Yes, we are fully insured with general liability and workers' compensation coverage. Your property and our crew are protected.
What maintenance does a metal roof need in Chalmette's climate?
In our humid, storm-prone climate, we recommend an annual inspection to check for loose fasteners, debris buildup, and any signs of wear. Cleaning gutters and removing fallen leaves and branches is also important. We offer maintenance plans and inspections to keep your roof in good shape.
Why choose us?

Trusted professionals in New Orleans

🏅

Licensed contractors

Continuous training, professional equipment, meticulous and code-compliant work

🛡️

Licensed & Insured

Full coverage on all our job sites, no exceptions

⚡

Available Mon-Sun 7am-7pm

Emergencies, weekends, holidays: available when you need us

💰

100% Free Quote

Response within 24h, no commitment, by phone or form

Our services

Our Metal Roofing Services in New Orleans

All your work handled by qualified professionals in New Orleans

Metal Roof Installation

Complete metal roof systems engineered for your local climate and built to outlast three shingle roofs.

Included in your service

  • Deck inspection and repair before any panel goes on
  • High-temp synthetic underlayment and correct ridge and soffit ventilation
  • Manufacturer-certified panel, trim, and flashing details for the full warranty
  • Free on-site assessment and written estimate within 24h
Learn more→

Standing Seam Metal Roofing

Concealed-fastener standing seam: no exposed screws to loosen, leak, or need re-torquing.

Included in your service

  • Panels roll-formed to the exact length of your roof, no end laps
  • Mechanically seamed or snap-lock profiles with concealed clips
  • Floating clip system that lets panels expand and contract freely
  • Kynar 500 / PVDF finish in the full architectural color range
Learn more→

Metal Roof Replacement

Full tear-off of an end-of-life shingle, cedar, or metal roof, replaced with a complete new system.

Included in your service

  • Tear-off and haul-away of the old roofing, dumpster included
  • Decking inspected board by board, rot and soft spots replaced
  • New underlayment, drip edge, valleys, and penetration flashing throughout
  • Documentation of the finished system for your insurer or future buyer
Learn more→

Metal Roof Over Shingles (Retrofit)

Retrofit metal installed over sound existing shingles: no tear-off, less waste, lower cost.

Included in your service

  • Honest deck and shingle assessment first, recover only when it is the right call
  • Furring strips or slip sheet as the panel profile and local code require
  • Existing vents, pipe boots, and flashings reworked to the new roof plane
  • Straight guidance on when tear-off is the better long-term choice
Learn more→

Metal Roof Repair

Targeted repair of damaged, loose, or storm-hit metal roofing before it reaches your ceiling.

Included in your service

  • Bent, dented, or punctured panels replaced and color-matched
  • Seams, laps, and penetrations resealed with compatible butyl and sealant
  • Failed pipe boots, closures, and ridge cap fasteners renewed
  • Written findings with photos of what we found and what we fixed
Learn more→

Metal Roof Leak Repair

Priority leak response: we trace the leak to its real source instead of caulking the symptom.

Included in your service

  • Water testing and interior tracing to find the true entry point
  • Backed-out fasteners, separated seams, and flashing gaps corrected at the cause
  • Emergency tarping available same day after a storm
  • Attic and insulation moisture check so hidden damage does not sit and spread
Learn more→

Screw Replacement & Re-Fastening

The top cause of leaks on 15 to 30 year old screw-down roofs, fixed for a fraction of replacement.

Included in your service

  • Every fastener replaced with oversized screws and new EPDM sealing washers
  • Dried-out washers and stripped holes addressed panel by panel
  • Ridge, eave, and sidewall closures renewed at the same time
  • Restores a watertight roof without replacing sound panels
Learn more→

Corrugated & Ribbed Panel Roofing

Corrugated, tuff-rib, and 5V panel roofing: the budget-friendly workhorse for homes and outbuildings.

Included in your service

  • Galvalume and painted steel panels cut to length on site
  • Correct screw pattern and torque so washers seat without over-driving
  • Foam and metal closures at ridge, eave, and rake to keep weather and pests out
  • Full color range for homes, cabins, barns, and workshops
Learn more→

Metal Shingle Roofing

The look of architectural shingle, slate, or shake with the lifespan and wind rating of steel.

Included in your service

  • Interlocking stamped steel or aluminum shingle panels
  • Walkable finished surface, easier to service than a standing seam field
  • Lightweight enough for retrofit over an existing roof structure
  • Profiles and colors that suit historic and HOA-governed neighborhoods
Learn more→

Stone-Coated Steel Roofing

Steel strength under a textured stone finish, with strong hail and wind performance.

Included in your service

  • Acrylic-bonded stone granule surface over structural steel
  • Battened or direct-to-deck installation depending on the profile
  • Class A fire rating and high impact resistance ratings
  • Tile, shake, and shingle textures for suburban and coastal homes alike
Learn more→

Copper & Specialty Metal Roofing

Copper, zinc, and aluminum for porches, bay windows, dormers, and full architectural roofs.

Included in your service

  • In-house fabrication of pans, valleys, and custom curved details
  • Soldered seams and joints where the detail calls for it
  • Isolation of dissimilar metals to prevent galvanic corrosion
  • A living patina that develops over decades of service
Learn more→

Metal Roof Coating & Painting

Restoration for faded, chalking, or surface-rusted metal, adding 10 to 15 years without replacement.

Included in your service

  • Wash, degrease, and mechanical prep of the entire panel surface
  • Rust treatment and primer on affected areas before topcoat
  • High-performance elastomeric or silicone coating system applied to spec
  • Honest assessment first: we say so when the roof is past coating
Learn more→

Flashing, Chimney & Skylight Repair

Flashing is the number one leak point on any metal roof, and it is what we fabricate best.

Included in your service

  • Custom bent step, counter, and apron flashing made in-house
  • Chimney crickets to shed water on the uphill side
  • Skylight curbs and head flashing rebuilt to the panel profile
  • Valley and wall transition details closed with matching trim
Learn more→

Snow Guards & Ice Protection

Snow retention that stops rooftop avalanches onto decks, gutters, walkways, and entryways.

Included in your service

  • Pad-style guards or continuous rail systems matched to your panel
  • Layout calculated from roof pitch, panel length, and local snow load
  • Clamp-on mounting on standing seam, no panel penetrations
  • Ice dam and eave detailing for higher-elevation homes
Learn more→

Storm & Wind Damage Repair

Wind, hail, and fallen-limb repair with thorough documentation and a straight repair-or-replace answer.

Included in your service

  • Free post-storm inspection with dated photo documentation
  • Emergency tarping and temporary weatherproofing when needed
  • A written report you can use when documenting your insurance claim
  • Honest assessment of repair versus replacement, with no pressure either way
Learn more→

Metal Roof Inspection

A written, no-obligation assessment of fastener condition, seams, flashing, and remaining service life.

Included in your service

  • Fastener, washer, and seam condition checked across the field
  • Flashing, penetrations, and closures inspected point by point
  • Coating wear, chalking, and corrosion graded panel by panel
  • Written report with photos and a straight answer on years remaining
Learn more→

Gutters for Metal Roofs

Gutters sized and hung correctly for metal roofing, where standard hangers and spacing do not work.

Included in your service

  • Seamless aluminum or half-round systems formed on site
  • Hanger placement and spacing matched to the panel profile
  • Oversized capacity and downspouts sized for heavy regional rainfall
  • Bracket spacing tightened for high-wind zones so storms do not tear the gutter off
Learn more→

Commercial & Agricultural Metal Roofing

Barns, workshops, churches, and light commercial metal roofing across the county.

Included in your service

  • Long-run panels for wide spans and low-slope structures
  • Purlin and framing attachment detailed for the building type
  • Insulation, vapor barrier, and condensation control options
  • Repairs and re-fastening for aging agricultural metal buildings
Learn more→
Verified client reviews

273+ Verified Client Reviews in New Orleans

⭐⭐⭐⭐⭐ 4.9/5 · 273 verified Google reviews

Free Quote

Get Your Free Quote

Metal Roofing in New Orleans · Response within 24h · No commitment · ☎ (504) 636-6074

Your Free Quote Request

Confidential · Response within 24h

✅ Free personalized estimate ⚡ Response within 24h 🛡️ Licensed & Insured 📍 On-site visits included in New Orleans ✅ No hidden fees 🕐 Available Mon-Sun 7am-7pm